PDA

View Full Version : Not able to conect trhu console.

SeRi@lDiE
08-31-2003, 1:04 PM
OK I have no idea but some reason I can not connect thru console...
My settings are as follow...

COM1.
Set Bits per second to 38400, Data Bits 8, parity none, Stop Bits 1, Flow control None

What am I doing wrong?
Mntsnow
08-31-2003, 1:11 PM
Is this for the Cisco 67x? if so slow down your speed and try again.
SeRi@lDiE
08-31-2003, 2:15 PM
Yes for the 678...
It worked fine before so thats why I freaked out...
Let me slow down the speeds and see what happen...
BRB
:)
SeRi@lDiE
08-31-2003, 2:19 PM
No is not respinding at all I even change to a diferent com port and no go....
SeRi@lDiE
08-31-2003, 5:08 PM
Any ideas?
Mntsnow
08-31-2003, 6:33 PM
have you tried going clear down to 9600 on port speed? Are you sure nothing is conflicting with your com port?
SeRi@lDiE
08-31-2003, 9:21 PM
No no conflicts...
Yea I whent all the way down to 9600...
Would it be safe if I turn the modem off and back on to see if that would do the trick?
Mntsnow
08-31-2003, 9:31 PM
You certainly can try power cycling your cisco... What was the last thing you did in the cisco before you found out you couldn't console back into it?
SeRi@lDiE
08-31-2003, 9:39 PM
All I did was setup the modem to Bridge mode just like you told me in the past thread....
I just power cycle the modem and still nothing :(
What happen to my modem?!?
Mntsnow
08-31-2003, 9:50 PM
You must have something messed up in your config as nothing that was suggested to you would have turned off the console
SeRi@lDiE
08-31-2003, 9:58 PM
It was working fine Before.... I just formated my computer could that be the problem?
Mntsnow
08-31-2003, 10:07 PM
I wouldnt think so unless something is up with your Hyperterminal application
SeRi@lDiE
08-31-2003, 10:18 PM
Good news I just got in!!!
:D
I change the IRQ to auto and it worked!!!
Wierd because there was no conflict!
:?
Any wais thanks once again Mntsnow!!!!
:D
SeRi@lDiE
08-31-2003, 10:21 PM
I for got was the default IP for the web interface!
I think it was 10.10.10.2 or some thing like that ?:
Mntsnow
09-01-2003, 12:56 PM
it should be 10.0.0.1