rfc1483 management help.

[SeRi@lDiE]

ok guys for quite some time I been trying to get in to the remote management of my Ciso 678...
here is how I have it set

set bridging management enabled
set int eth0 address *.*.*.* (Internal IP set by router)
write
reboot
Set web remote *.*.*.*
Set web port *****
write
reboot


And still I cant get in.... any ideas why?
TIA! :)

[SeRi@lDiE]

Any body?

[Mntsnow]

Is is possible that your ISP is blocking traffic on the WAN side at the port you are trying to access?

[SeRi@lDiE]

I doubt it because the port is set to 34000

[Mntsnow]

and how were you and from where are you trying to connect to it it remotely?

[Mntsnow]

Set web remote *.*.*.*
Set web port *****
write


Me thinks you might have missed a step....

set web ENABLE
set web remote *****
set web port *****

then write and reboot.....looks like you set the remote and port but you didnt ENABLE the actual service :)

[SeRi@lDiE]

No I did that I just missed posting it.
Any other ideas?

[SeRi@lDiE]

Ok here is what shows in my config

[[ Spanning Tree = Section Start ]]
MAC Bridge = enabled, rfc1483
MAC Bridge Management = enabled
[[ DHCP = Section Start ]]
[[ ATM WAN Device Driver = Section Start ]]
ATM WAN Virtual Connection Parms = 00, 0, 35, 0
[[ WEB = Section Start ]]
WEB Port Number = *****
WEB = enabled
[[ IP Routing = Section Start ]]
IP Port Address = 00, 192.168.168.40

[SeRi@lDiE]

So any thing out there?

[Mntsnow]

Sorry I'm drawing a blank at this moment